List of polygon point data (Output Table)

Table description:

The output data table SHAPEP provides information on the polygon points calculated. The angle BEND is determined between the 'arriving' polygon line and the 'leaving' polygon line at a polygon point. For mitre bends this is the geometrical bend radius. The equivalent bend radius is reported in BENDFAC.

The projection of this angle on the X-Y plane is contained in H.BEND. (in case of a horizontal bend plane BEND = H.BEND, in case of a vertical bend plane H.BEND = 0.º). The angle between the vertical Z-axis and the 'leaving' polygon line is contained in V.BEND. (in case of a horizontal 'leaving' polygon line V.BEND = 90.º, in case of a rising line V.BEND < 90.º and a descending line V.BEND > 90.º)




H200512, last changed: 2009-07-17

See also:

Data description/conditions

Table error description

Design Function 2